how to secure retaining wall caps

For this repair of a concrete retaining wall I used a wire brushscraper tool to knock down the existing glue and the stick-to-anything construction. How To Secure Retaining Wall Caps - Use a flexible masonry adhesive np1 or equivalent to secure the capstones in place.

How To Build A Block Retaining Wall

This should be done on both your.

. To remove retaining wall caps. From underneath mark the front and back on the right and left sides. By Williamstown in forum Retaining Walls.

Pry the retaining wall cap off the wall with a pry bar. Leave a space 3 inches narrower than your cap between the edge of your first cap and. Loosen the retaining wall cap with a crowbar or chisel.

We provide step-by-step instructions for capping a small concrete block retaining wall. They pop off very easily probably due to differences in expansion of the. To get a consistent point use the 45 chamfers at.

Line up the chisel with the seam and tap the end of the chisel with a hammer to make the first break in the seam. The only drama is that mortar believe it or not doesnt hold the caps as well as the glue. Lift and place your first cap so that it overhangs the end of your retaining wall on the side and face.

To create a snug fit youll mark where the overhanging cap meets the other cap. Scrape any remaining mortar from the.

How To Install Steps With Retaining Wall Blocks Hilgersom Inc